Deformation characteristics and selection requirements of Auto Rubber Buffer For Honda

- Apr 16, 2019-

The shape of the Auto Rubber Buffer For Honda can be arbitrarily selected, so that the stiffness in the up, down, left and right, and front and rear directions can be obtained by reasonable design of the damping element, which greatly simplifies the structure of the shock absorber.


Honda's rubber bumper block has three-direction deformation characteristics, allowing for large errors during installation. Rubber and metal can be firmly combined. Due to the damping characteristics of rubber, the absorption vibration energy is converted into heat energy, and its vibration-absorbing ability is much larger than that of metal, especially suitable for high-frequency vibration.


Honda's rubber buffer block is simple in structure, easy to use and maintain, requires almost no repair, no wear, no rust, no oil lubrication, is not sensitive to the action of water and dust, does not cause sudden damage during use, and is safe and reliable to use. Low cost and long enough life. The shape can be freely determined, and the hardness can be controlled by adjusting the rubber formulation components to meet the requirements for stiffness and strength in all directions.


Honda's rubber buffer block has large internal friction and good shock absorption effect, which is good for crossing the resonance zone and attenuating high-frequency vibration and noise. The elastic modulus is much smaller than that of metal, which can produce large elastic deformation, no sliding part, and easy maintenance. . The rubber shock absorber is small in quality and easy to install and disassemble.