Installation method of Suspension Strut Bumper Front

- Apr 08, 2019-

The distance between the Suspension Strut Bumper Front is a concern to be placed in front of the suspension strut bumper. What consumers need to master is that "this distance is equal to the length of the front of the suspension pillar bumper." If it is more difficult to squeeze by hand, loosen the screws of the shock absorber and let the shock absorber spring relax 2-3 cm.


Under normal circumstances, the front of the bumper of the car suspension pillar is installed in the middle of the spring. When installing, try not to use the tool to press, so as not to damage the front of the suspension pillar bumper. Of course, before doing the above steps, first use the jack to support the body and wash the spring with water.


After the installation is completed, rotate the car shock absorber buffer a few times to the left and right to check whether the springs are all loaded into the spring groove; whether the outer edge of the buffer is smashed by the mudguard; whether the buffers overlap. At the same time, in order to prevent the shock absorber from sliding down to the bottom of the spring while the car is running, a stop card can be installed.