Now that the installation principle of the front bumper spring for VW has been clarified, the installation can be started, but the installation position of the support should be measured before the Volkswagen front bumper spring is installed. The support installation plane should be the sliding plane of the support or The rolling plane is parallel, and the deviation of the parallelism should not exceed 2‰.
At the same time, the relative position of the movable support top and bottom plate should be checked before the front bumper spring for VW is installed. After the Volkswagen front bumper spring is installed, the rolling and sliding planes should be horizontal, and the slope of the theoretical plane should be no more than 2‰. The center of the upper and lower plates of the support should be handled with a deviation of no more than 2‰.
The Volkswagen front bumper spring mounted in place has sufficient vertical stiffness to reliably transmit the reaction force of the upper structure of the support to the lower part; and it has good elasticity to cope with the vibration of the vehicle; its larger shear The cutting ability can meet the horizontal displacement of the upper structure.